|
The ten key concepts are
broken further into lessons. This lets us consolidate what students must
learn at one sitting. |
28 Lessons!
- Machine configurations
- Speeds and feeds
- Visualizing program execution
- Understanding program zero
- Measuring program zero
- The two ways to assign program zero
- General flow of programming
- Introduction to programming words
- Preparation for programming
- Motion types
- Introduction to compensation
- Dimensional (wear) offsets
- Tool nose radius compensation
- Geometry offsets
- Introduction to program formatting
- The four kinds of program format
- Simple canned cycles
- Rough turning and boring cycle followed by
finishing
- More multiple repetitive cycles
- Thread programming
- Subprogramming techniques
- Control model differences
- Other special features of programming
- The control panel
- The machine panel
- The three modes of operation
- The key operation procedures
- Program verification
|
